The new, modern, seamless stone finish for any surface.
True Stone is Diamond Coat's premium microcement system, a thin, hand-troweled cement coating that transforms floors, walls, countertops, and showers into one continuous, modern surface. No demo. No grout. No seams. Installed by our own crew out of Grand Junction, Colorado, with travel available nationwide for full-home and whole-room projects.
A handcrafted finish that goes over what you already have.
True Stone is Diamond Coat's branded microcement system, a cement, polymer, and mineral pigment coating troweled on in razor thin layers. The result is the warmth and depth of polished concrete, but at a fraction of the weight and without the cracks or expansion joints.
Because it is only 2 to 3 millimeters thick, True Stone bonds directly to tile, drywall, plywood, concrete, and most existing surfaces. That makes it the cleanest way to modernize a kitchen, bathroom, or commercial space without tearing anything out.
We have spent the last 15 years perfecting resurfacing systems. True Stone is the latest addition to the Diamond Coat lineup, and we install it ourselves so the result meets the same standard as everything else we put our name on.
One material. Four surfaces. Zero seams.
Use True Stone to unify a whole room, from floor to wall to vanity to shower, in a single continuous tone.
Floors
Living rooms, kitchens, retail, and commercial spaces. Applies over tile, concrete, or plywood.
Walls
Feature walls, full bathrooms, and entryways. Goes directly over drywall or existing tile.
Countertops
Kitchen islands, vanities, and bartops. Warm, matte, and food safe once sealed.
Showers
Fully waterproofed wet rooms with no grout to scrub. A favorite for modern primary baths.
Backed by 15+ years of resurfacing expertise.
We have been resurfacing kitchens, garages, and pool decks across 40+ states since long before microcement was trending. True Stone brings that same craft, materials science, and finish quality to one of the most sought after surfaces in modern design.
No demolition
Applies directly over existing surfaces: tile, concrete, drywall, plywood. Keep your subfloor and lose the dumpster.
Seamless and grout free
One continuous surface from floor to wall to counter. Nothing to scrub between, nothing to re caulk.
Custom color matched
Choose from warm putty to deep charcoal, matte to soft sheen. We can color match almost any reference.
Waterproof when sealed
True Stone uses a multi layer sealer system engineered for wet rooms, kitchens, and high traffic floors.
Lightweight
At 2 to 3 mm, True Stone adds almost no load. Perfect for second floor bathrooms and renovations where weight matters.
Installed by our team
True Stone is installed by Diamond Coat directly, or routed to a vetted partner. No anonymous subcontractors.
Headquartered on the Western Slope. Available across the country.
We are based in Grand Junction, Colorado and serve the entire Western Slope in person: Grand Junction, Montrose, Durango, Telluride, Aspen, Vail, Glenwood Springs, and everywhere in between.
For projects elsewhere in the United States, our crew travels for whole-room and full-home work, and we have a growing list of trusted partners we can route smaller jobs to. Tell us about your project below and we will let you know whether we are the right fit.
Request an estimateWe work directly with the trade.
If you are specifying finishes for a client, we can supply samples, custom color matching to your palette, written specs for your submittal package, and coordination with your general contractor's schedule. Tell us you are trade when you reach out and we will route you to Levi directly rather than through the standard estimate queue.
Two great finishes. Different jobs.
We offer both so we can recommend whichever is right for your project. Here is how they compare.
| True Stone Microcement | Diamond Coat Epoxy | |
|---|---|---|
| Look | Matte, natural, hand troweled concrete | Glossy, marbled, custom pigmented resin |
| Feel | Soft, stone like, slight texture | Smooth, glass like, solid |
| Thickness | 2 to 3 mm | 1/8 in. to 1/4 in. (3 to 6 mm) |
| Best for | Modern minimalist interiors, wet rooms, full surface unification | Countertops, garage floors, river tables, pool decks |
| Install time | 3 to 5 days (multi coat with cure between) | 1 day for most countertops |
| UV stable outdoors | Yes, with the appropriate sealer | Yes, non yellowing |
| Typical project | Starts at $10,000 installed | DIY kits and smaller installed jobs |
What to expect, start to finish.
Every True Stone project follows the same four phase process. The exact timing depends on your square footage, substrate, and chosen finish, but the sequence does not change.
For Western Slope projects we typically have a crew on site within two to three weeks of an approved estimate. Out of state projects are scheduled based on travel and crew availability.
Consultation
Tell us about your space. We will walk through colors, finish, scope, and whether your project is a fit for our team or a partner.
Surface prep
We clean, prime, and reinforce the substrate. Existing tile, grout lines, and minor imperfections are bridged before any True Stone goes down.
Application
Two to three thin coats troweled by hand, each cured before the next. This is where the depth, movement, and character come from.
Seal and cure
A multi layer sealer locks in waterproofing, stain resistance, and durability. Most spaces are walkable within 48 hours.
Everything you need to know.
Most True Stone projects run between REPLACE_ME and REPLACE_ME per square foot installed, depending on surface, prep required, color, and finish. Projects start at $10,000, which typically covers a full bathroom or a mid-size floor. Whole-home and multi-room work is quoted individually. If your project is smaller than that, our epoxy systems are usually the better answer.
Polished concrete is the slab itself, which requires a structural concrete floor and aggressive grinding. True Stone is a 2 to 3 mm coating applied over an existing surface (tile, plywood, drywall, even countertops), giving you the same look without any demolition or structural work.
Yes. When properly sealed with the right primer and topcoat system, True Stone is fully waterproof and is one of the most popular finishes for modern wet rooms and walk in showers. Our team uses a shower rated buildup specifically engineered for wet areas.
True Stone is reinforced with fiberglass mesh during application and contains polymer additives that give it flex traditional cementitious finishes never had. On a properly prepped, stable substrate it resists cracking far better than concrete overlays.
Most residential projects take 3 to 5 days on site: surface prep, two to three coats of True Stone with cure time between, and final sealing. Larger commercial spaces may take longer. The space is typically walkable within 48 hours of the final coat.
We service the entire Western Slope of Colorado in person and travel for projects across the rest of the United States. Submit the form below with your location and we will let you know whether we will install directly or route to a vetted partner.
Day to day cleaning is just a damp mop or microfiber cloth with a pH neutral cleaner. Avoid abrasive pads and harsh acidic cleaners. With normal residential use, the sealer holds up for years. High traffic commercial floors benefit from a fresh topcoat every few years.
True Stone is a professional application material. The trowel technique, layer timing, and sealing system genuinely matter, which is why we install it ourselves. For DIY friendly finishes, see our Diamond Coat epoxy systems.
Trusted across the Western Slope and beyond.
A few words from homeowners and businesses who've had Diamond Coat transform their spaces.
"Levi and his team completely transformed the reception hall at our wedding venue. We went from bingo hall to ballroom. The gasps from our booked couples once they saw the floors and accent wall were non stop. We've had a 100% booking rate since. Excellent at their craft, and very professional and friendly."
"Diamond Coat is amazing! Levi and team did a fantastic job on our courtyards, just beautiful. Highly recommend, all five stars."
"WOW! What a great company and a great job. Amazing family owned business, we are so happy with the outcome. Our 3-car garage looks fantastic. We highly recommend!"
"We had our warehouse floor leveled and covered with epoxy and it turned out great. Perfect for our manufacturing environment and it has held up great with forklifts, scissor lifts, and pallet jacks."
Ready to see your space in True Stone?
Tell us about your project and our team will get back to you within one business day. Western Slope projects are handled directly. For everything else, we will let you know whether we are traveling to your area or routing to a trusted partner.
- Projects start at $10,000 installed
- Photos help us quote faster and more accurately
- Color and finish consultation included
- Trade inquiries go straight to Levi
- Your information is never sold or shared